Control mechanisms

 

PRESSURE SWITCH

Installed in the collector or discharge piping and it is used to detect a pressure surge in the collector, caused by the release of the agent.  Ease of electrical connection to the detection panel, NO or NC. Rapid reset, just by pulling the side knob.

 


FLOW DETECTOR

Installed primarily in section or control valves, But can also be installed in the water collector or Discharge piping. Effective and reliable for its simplicity in operation.

 


PRESSURE SWITCH

RG Systems offers a wide range of pressure switches for different demands of working pressure. Depending on the area of application, there are measuring pressure switches made of galvanized carbon steel with IP54 protection, with regulatory pressures ranging from 20 to 300 bars, or ATEX pressure switches made of stainless steel for the more demanding and varied processes within the category of explosive environments.

 


PRESSURE GAUGE

Devices that are reliable and simple to use, that allow for visual inspection at all times while continuously controlling the pressure inside the cylinder. If it is low, it sends an alert signal to the fire panel.

 


CONTINUOUS WEIGHING SYSTEM

Because it is completely mechanical, it can be used anywhere, independent of service conditions. It does not require external energy supplies, so its operation is guaranteed even in blackouts or explosions.

 

 


LIMIT SWITCHES FOR SHORT, DIRECTIONAL VALVES, ETC.  

Compact limit switches used by RG Systems are small and resistant. They are ideal for assembly in very small areas- and can be used in similar way to the traditional NEMA style limit switches.

 

 

 

Documentation 

The quality of each component differentiates the system from its competitors.